Your 89 acura legend if you have the wrong timing and you try to start your car what can happen to your engine?

1. Can timing stop a car from starting?
2. What noise does a car make when the timing belt breaks?
3. What happens when your timing belt comes off?
4. What does it mean when your car starts but wont stay on?
5. What is wrong with my car if it turns over but wont start?
6. How do I reset my engine timing?
7. What happen if the timing mark between injection pump and camshaft timing mark would not align?
8. Is there any warning before timing belt breaks?
9. Will your car start if the timing belt is broken?
10. Can you drive with a broken timing belt?
11. How much does it cost to fix timing belt?
12. How do I check my timing belt?

Can timing stop a car from starting?

Timing belt or chain – When there is lack of compression, it can also prevent your car from starting. It might crank but you will never be able to get your engine to start.

What noise does a car make when the timing belt breaks?

First symptom of a broken timing belt: the engine ticking.

If you hear a strange ticking sound coming from inside the engine, then stop the car immediately. After stopping, open the bonnet safely and, paying attention to the hot parts of the engine, visually check the condition of the belt.

What happens when your timing belt comes off?

What happens if the timing belt breaks? If a timing belt breaks, the engine will no longer work. ... This may result in a heavy damage to the engine with broken or bent valves, damaged pistons and, possibly, destroyed cylinder head and block.

What does it mean when your car starts but wont stay on?

This issue could be caused by an insufficient amount of fuel reaching the combustion chamber. For fuel issues, start by checking the fuel pressure. ... With too much air in the engine after the MAF sensor, the engine runs so lean it can't properly combust the fuel air mixture, and it stops operation.

What is wrong with my car if it turns over but wont start?

When your engine cranks but won't start or run, it could mean your engine is having trouble producing a spark, getting fuel, or creating compression. The most common causes are problems in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter).

How do I reset my engine timing?

To adjust your timing, all you need to do is turn the distributor housing one direction or the other, depending on whether or not you want to advance or move back the timing. If the rotor turns clockwise, you'll advance the timing by rotating the distributor counterclockwise, and vice versa.

What happen if the timing mark between injection pump and camshaft timing mark would not align?

Best case scenario: The engine starts but runs poorly. Codes may set such as cam/crank correlation, misfire, etc. At best the engine will not operate correctly, at worst a broken valve and/or combustion chamber, cylinder and piston damage.

Is there any warning before timing belt breaks?

The timing belt can fail without any prior symptoms, so if you're within the mileage window, you should go ahead and have it replaced regardless. That being said, sometimes your car will give you a bit of warning that the belt is wearing out.

Will your car start if the timing belt is broken?

When your car's timing belt is broken or irreplaceable, your engine will not be able to ignite or turn over properly. This means when you turn the key, you may hear the starter motor engage, but since the timing belt is responsible for operating the crank and shaft, it will not fully ignite.

Can you drive with a broken timing belt?

You can't exactly ignore this problem if your car won't start then you can't drive it. However, if the timing belt breaks while you are driving you will definitely notice and there will almost certainly be additional damage to your engine.

How much does it cost to fix timing belt?

The average cost to replace a timing belt will be anywhere from $300 to $500 in total (more for larger cars, trucks, and SUVs). The timing belt itself will usually only cost less than $50 but the majority of a timing belt job is spent on labor. The cost of the labor will be anywhere from $250 to $450 or more.

How do I check my timing belt?

Look for any contaminants that could eat away at the belt or cause it to slip. Also, look for cracks in the belt. If the belt has many cracks in it, this can indicate that the belt is old or has dried out. Next, inspect the underside of the belt and verify that all the teeth are in good condition.